Clik here to view.
DJI Naza part II
The build with Turnigy ESC was troublesome as the flight controller would (most of the time) reset the ESC on power up. It is an drag to calibrate the ESC. So i purchased two DJI Naza flame wheel F450...
View ArticleClik here to view.
DJI Naza part III
Today i exchanged the two camera’s for the GoPro HD 2. Took it for a spin inside which went well, without fiddling with gain settings. Nice, time to take it outside. The maiden flight with the GoPro...
View ArticleDJI Naza part IV
I could not really find an problem with the wiring nor the bullet connectors. To exclude the later, i re-soldered the bullet connectors with proper solder i.e. solder containing lead. To test the...
View ArticleClik here to view.
DJI Naza part V
Got borred with the two Naza quads. so scrapped them.Build the DJI Naza F550 hexa copter with GPS. Everything is DJI except for the tx, which is a FrSky D8R-II.
View ArticleClik here to view.
DJI Naza part VI
One drawback of an hexa or an octa (not possible with the NAZA FC) is the sheer size of the craft. Foldable airframes or airframes with removable legs cost a fortune e.g. the DJI S800 V2 aka “Spreading...
View ArticleClik here to view.
DJI Naza part VII
Made a X6 (Hexa Y) from scrap i had lying around. Currently 3S with 10″ DJI props and without FPV. The booms are from Mikrokopter but they don’t make them any more. Getting it in the air and hover is...
View ArticleClik here to view.
RC FPV part 7
This is a follow-up of part 6. The gimbal i want is still not out yet. So i ordered two gimbals ($99 each) from RCtimer. Well i was not the only one… Made an adapter to hold the gimbal on the DJI Naza...
View Article
